Mustang Motorcycle Seats Concho Kit, Large, 41mm (1.625") Diameter - Manual

Installation Instructions for Conchos
Concho Features:
Conchos are custom-made from heavy die-cast zinc, not a thin
stamping, and include a genuine leather strap. The conchos are
available in two sizes.
• Small Concho - used for sissy bar pads - 32 mm (1-1/4")
diameter with leather strap
• Large Concho - used for seats and tank bibs - 41 mm (1-5/8")
diameter with leather strap
Concho Installation Steps
1. Position concho strap with the rough side of material
facing out as shown.
2. Insert concho strap through slits in seat so that round
holes in strap are positioned above and below slits.
NOTE: If the seat material does not have pre-cut
slits, you must cut them to the dimension shown in
photo .
3. Slide upper portion of concho strap through the upper
slot in concho from behind. Slide lower portion of
concho strap through the lower slot in the concho in a
similar manner. Pull strap ends tightly enough for the
two holes in the strap to be visible.
4. Insert tip of upper strap into lower hole in concho strap
and pull through tightly (fig.1). Lower has now become
the new upper strap (fig. 2).
5. Insert tip of new upper strap end into the unused
lower hole in the concho strap and pull through
tightly.
6. Finished product should display one smooth side and
one rough side of the concho strap.
These steps are guidelines to help you install your new Mustang product. If you need further assistance please call us
at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern or send an e-mail to [email protected] or visit
our website at www.mustangseats.com .
For care and maintenance of our seats, please go to our website under "Support".
Ref: part #s 78022, 78024
Step 1
Step 3
Step 4 (fig 1)
Step 2
Step 5 Step 4 (fig 2)