Mustang Motorcycle Seats Covered Hard Trunk Plain - Manual

1. Install trunk brackets against fender struts using supplied bolts
and spacers (fig. 1). Note: If bike has saddlebag brackets, install
trunk brackets between fender struts and the saddlebag
brackets.
2. Adjust the trunk brackets until the rear part of the two brackets
are postioned horizontally, then tighten the mounting bolts (fig.
2).
3. Place the trunk on the brackets, adjust the position of the trunk
to the best position. Check the clearance between the trunk and
the opening of saddlebags if installed (fig. 3).
4. Mark mounting holes with a wax pencil or put painter’s tape on
the estimated area to be drilled (fig. 4).
5. Drill the marked points with 5/16” drill bit. Put the trunk on
protective material up side down or drill the mounting holes
with the trunk on the brackets (fig. 5). Note: When drilling
mounting holes in trunk, please use caution to prevent
tearing carpet.
6. Install the trunk with the M6 x 15mm Button Head Bolts, Lock
Washers and 12mm Flat Washers provided.
Fig. 1
Fig. 2
Fig. 3
Fig. 4 Fig. 5
Fig. 6
These steps are guidelines to help you install your new Mustang Product. If you need further assistance, please
call us at 800‐243‐1392 or 860‐582‐9633, Monday through Friday 9:00 – 5:30 Eastern or send an e‐mail to
[email protected] or visit our website at www.mustangseats.com .
For correct Bracket and Bolt Kit Information, please go to our website under “Support”.
Refers to part numbers: 13304, 13305
Supplied Hardware:
(6) M6 x 15mm Button Head Bolts
(6) 12mm Flat Washers
(6) Lock Washers
Necessary bolts & spacers to fit specific application
Mounting Suggestions
Covered Hard Trunk