beautypg.com

Mustang Motorcycle Seats Wide Touring Two-Piece Vintage Seat - Honda VTX 1800 Retro, No Studs, No Conchos User Manual

Mustang Motorcycle Seats For motorcycles

background image

Mounting Suggestions:

Honda VTX 1800 Retro, S & T 2002-08

Two-Piece Seat

Hardware:

• Stock 8 mm Allen Bolt
• 1/4”-20x3/4” Bolts (Included)

Baseplate Features:
The two-piece, marine-grade fiberglass
baseplate is a direct replacement for the stock
two-piece seat. Rubber bumpers are positioned
to protect the frame and fender.

Stock Seat Removal Steps

1. Remove one 8 mm Allen bolt on each side of

the front of the passenger seat.

2. Remove 8 mm Allen bolt at back of passenger

seat. Lift pad up to remove.

3. Remove one 8 mm Allen bolt on each side of

solo. Lift back of solo up and slide back to
remove.

4. Unbolt U-bracket from center of fender. (This

will not be needed for mounting the Mustang
seat.)

5. Remove stock side mounting brackets from

base of stock solo. These will be needed for
mounting the Mustang solo.

Step 3

Step 1

Step 5

Page 1 of 2