Mustang Motorcycle Seats One-Piece LowDown Touring Seat Harley-Davidson Road King - Manual

Mounting Suggestions for the Harley-
Davidson® Road King, Road King Classic
1997-07, FLHRS (Custom) 2004-07, FLHT/
FLHR Screamin’ Eagle 1997-05 & FLHX
2006-07 One-Piece Seat
Tools Required:
• Phillips Screwdriver
• 5/8” Deep Socket or Open-End Wrench
• 7/16” Open-End Wrench
Hardware:
• Stock Rear Fender Screw
Baseplate Features:
One-piece touring seats are constructed on a marine-grade
fiberglass baseplate. The baseplate is slotted in the middle
to allow for the use of a Mustang or stock Harley-Davidson®
driver backrest kit.
NOTE: Seats will not work with an FLHT handrail
Stock Two-Piece Seat Removal Steps
1. Remove the rear fender screw. This screw will be used later to secure
your new Mustang One-Piece Seat.
2. Slide the passenger seat back and up.
3. Remove the solo mounting nuts (1999-07) or solo mounting bolts 5/16”x18
thread (1995-98) located at the back of the solo seat.
Stock Solo Seat Removal Steps
1. Remove the solo mounting nuts (1999-07) or solo mounting bolts 5/16”x18
thread (1995-98) located at the back of the solo seat.
2. Slide the solo back and up.
Stock One-Piece Seat Removal Steps
1. Remove the rear fender screw. This screw will be used later to secure
your new Mustang One-Piece Seat.
2. Remove hand strap that is secured to the motorcycle on each side of
the seat where the front saddle bag mount is located.
3. Slide the seat back and up.