Mustang Motorcycle Seats One-Piece DayTripper Seat Kawasaki Vulcan 900 Classic - Manual

These steps are guidelines to help you install your new Mustang product. If you need further assistance,
please call us at 800-243-1392, Monday through Friday 9:00 - 5:30 Eastern, or send an email to
[email protected], or visit our website at www.mustangseats.com.
For care and maintenance of our seats, please go to our website under "Support".
Ref part #75628, 76128, 76127, 76126, 79416, 79417
Mounting Suggestions
Kawasaki Vulcan 900 Classic 2006-20
11
& Custom 2007-2011
One-Piece Seat
Tools Required:
• 10 mm wrench
• 7/16” wrench
Hardware:
• Two 1/4-20 x 3/4” Bolts- Classic (Included)
• Two 1/4-20 x1” Bolts- Custom (Included)
• Two 3/8” Tall Spacers- Custom (Included)
Baseplate Features:
The one-piece marine-grade fiberglass baseplate is a
direct replacement for the stock seat. Rubber bumpers are
positioned to prevent the seat from touching the frame and
fender.
Stock Seat Removal Steps
1. Insert ignition key into left side cover and turn key clockwise to unlock stock seat.
2. Lift rear of seat up and then back to remove.
Mounting of Mustang Seat
1. Remove the latch pin bracket from the center of the stock seat with
a 10 mm wrench.
2. CLASSIC ONLY: Install bracket to seat using supplied 1/4-20 x 3/4”
bolts. Tighten with a 7/16" wrench. Do not over tighten bolts.
CUSTOM ONLY: Install spacers between stock bracket and seat.
Secure bracket and spacers with 1/4-20 x 1" bolts. Tighten with a
7/16" wrench.
Do not over tighten bolts.
3. Slide nose bracket of seat under the gas tank receiver. Push seat all
the way forward then down onto fender latch.
4. Push center of seat down until click is heard; seat is now locked.
Enjoy the comfort of your new Mustang Seat!