Ocean Optics XYZ Mapping Tables - Manual (Page 15)

3: Operating Instructions
000-10000-130-02-1209 7
Factory Settings
The following settings can be reset in the controller by sending them to each controller via RS232.
Ultimately, they must be stored in the EEPROM with the EEPSAV command.
CONTMOD
SOR0
POHOSEQ0
REFIN
ANSW0
HP3
HB3
HD2
HOSP100
HA0
HL3
HN1
CAHOSEQ
ADR
LPC2200
LCC2200
AC1100
I20
POR8
SP1000
MV0
MAV25
LL600000000
LL-600000000
LPN16
EN
V0
DIPROG
X-axis Y-axis Z-axis
NODEADR1 NODEADR2 NODEADR3
Caution
The node addresses (NODEADR) cannot be reprogrammed. To restore the factory
settings send the instructions listed above to the mapping table.
Changing these settings can lead to malfunction or damage.
ASCII Command Set
To send a command to a certain axis you need to add the node address to the command like shown below.
All commands must be completed by a carriage return (CR).