Buyers LT30 - Manual

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
LT30 Gas Can Rack
for Utility Landscape Trailers
—continued on other side
Holds one 5 gal. gas can or two 2-1/2 gal. gas cans.
Important!
Before you begin installing:
1. Read and understand these instructions
completely.
2. Verify that you have received all the parts
listed in the bill of materials.
CAUTION:
Always wear safety glasses when using power tools.
Utility Trailer Installation Instructions
Tools Required:
•9/16" Wrench or Socket
•7/32" Hexagon Allen Wrench
•Electric Drill
•13/32" Drill Bit
1. Place the gas can rack on the rail of your util-
ity trailer where you would like it mounted. Make
sure the rack does not extend past the widest
part of the trailer. Align the holes in the bottom
of the gas can rack with the center of the rail.
You may need to adjust the position of the rack
so the four slots in the bottom are clear of any
obstruction.
2. Mark the position of the two holes on the
trailer rail.
WARNING! Check for locations of brake lines
and electrical wiring etc., before drilling any
holes. Any damage to trailer during installation
is the installer’s sole responsibility.
3. Drill 13/32" holes in the positions marked.
4. Bolt the rack to the trailer with two 3/8-16
x 1-1/4 socket head cap screws, four 3/8" flat
washers, and two 3/8-16 nylock nuts supplied
and tighten.
5. Thread the free end of the strap through the
rack as shown for holding two 2-1/2 gal. cans or
thread the strap into the other slots for holding
one 5 gal. can. Then thread the buckle onto the
end of the strap as shown.
1 3004328 1 Rack, Gas Can, Rack Only
2 3004710 1 Strap, 60" Lashing w/Cam Buckle
3 - 4 Washer, Flat 3/8 USS Zn
4 - 2 Screw, Button Socket Head Cap, 3/8-16 x 1-1/4
5 - 2 Nut, Nylock 3/8-16 x 7/16 Zn
ITEM PART NO. QTY. DESCRIPTION
Bill of Materials