Buyers Underbody Toolboxes - Manual

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
3000105 Rev. B
Warranty Information
Buyers Products Co. warrants all truck/trailer hardware manufac-
tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts
must be properly installed and used under normal conditions. Any
product which has been altered, including modification, misuse,
accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of
Buyers Products Co. under this warranty is limited to repair-
ing or replacing any part or parts which are returned, pre-
paid, and are found to be defective by Buyers Products Co.
Authorization from Buyers Products Co. must be obtained before
returning any part. No charges for transportation or labor per-
formed on Buyers’ products will be allowed under this warranty.
To properly support your Underbody Toolbox, we
recommend the use of bottom support mounting
brackets. These brackets should be placed so that
each end of the toolbox is supported by the full
width of the mounting bracket. To prevent rust,
touchup drilled holes with aerosol paint. To pre-
vent water leaks, apply silicone sealant all around
each fastener after installation.
We offer three sizes of Universal Mounting Brackets
Part No. 1701005 - One pair of 18" x 18" brackets
Part No. 1701010 - One pair of 18" x 24" brackets
Part No. 1701015 - One pair of 24" x 24" brackets
WARNING
1. If the proper mounting brackets are not used, the tool-
box could drop off the vehicle while it is moving and cause
personal injury and/or property damage.
2. Mounting your toolbox through the top, back or sides
without bottom support will significantly reduce the
capacity and possibly the life of the toolbox.
3. Prior to any welding or drilling holes in a vehicle frame,
check for location of fuel tanks, fuel lines, brake lines or
electrical wires.
4. If welding is to be done on a vehicle frame in the mount-
ing of this toolbox, disconnect the cables from the battery
to prevent shorting of electrical components on the vehicle.
5. Always wear protective eyewear when drilling, welding
or checking the underside of a vehicle.
Toolbox Mounting Instructions
Please read these instructions and warnings before installation.
DANGER
Do not use this toolbox for the storage or transportation
of flammables, explosives, hazardous waste or materials
such as gasoline, solvents, gun powder, dynamite, propane
tanks, acetylene tanks or cutting torches. This toolbox is
only intended and safe for use in storing and transporting
small tools and equipment and/or other materials.
1701005
1701010
1701015