Buyers 85130, -40, -45, -50, -55 User Manual
Installation instructions, Accessories for window protectors, Load guide kit installation

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
Installation Instructions
Accessories for
Window Protectors
–continued
GENERAL INFORMATION
CAUTION:
1. Park your vehicle on flat, horizontal surface. Ap-
ply parking brake or use wheel chocks to prevent
accidental rolling.
2. To keep debris out of your eyes always wear
protective eyewear.
3. Check contents of box against part list to make
sure all components is included.
TOOLS REQUIRED:
Two 7/16" Wrenches, Open or Socket
Load Guide Kit Installation
1. Place U-shaped base of the Load Guide over
upper tubing of the Window Protector in desired
location.
2. Install all hardware as shown in Fig.1. Make
sure to place spacers into opening of U-shaped
base to prevent collapsing of this part.
3. Tighten nylock nuts to 20-30 ft-lbs. of torque.
FULL ONE-YEAR WARRANTY
Manufacturer will repair, or at manufacturer’s discre-
tion will replace any part of this Window Protector
which proves to be defective in workmanship or mate-
rial under normal use for period of one year from the
date of delivery to the original purchaser. Any cost
incurred in returning the product to the supplier is the
responsibility of the consumer.
EXCLUSIONS
Manufacturer shall not to be liable for special, incidental,
or consequential damages or for damages resulting from
lack of necessary maintenance, from misuse, abuse, act
of God, or alteration of the product. Some states do not
allow the exclusion or limitation of incidental or conse-
quential damages, so the above limitation or exclusion
may not apply to you.
This instruction sheet describes installation
of the following accessories:
• Load Guide Kit, #85130
• Kit for Strobe Light 6-1/2" OD, #85140
• Kit for Utility Light 10-1/4" OD, #85145
• Kit for Minilight Bar, #85150
• Kit for Antenna/Spotlight, #85155
Important: Installation Instructions, Warranty
Information. Place in vehicle glove box after
installation.
PART NO.
QTY.
DESCRIPTION
3003335
2
Load Guide
3003913
4
Spacer
FNE025020031
4
Nut, Nylock 1/4-20
FWF025063007
8
Washer, Flat 1/4"
3004435
4
Screw, Hex Cap 1/4-20 x 2-1/4"
3003919
1
Instruction Sheet
Fig. 1