beautypg.com

Buyers LT10 User Manual

Page 2

background image

Quality since 1946

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (440) 974-0165

Toll-Free Fax 800-841-8003 • buyersproducts.com

3004410 Rev. B

WARRANTY

Buyers Products warrants all truck/trailer hardware manufactured or
distributed by it, to be free from defects in material and workman-
ship for a period of one year from date of shipment. Parts must be
properly installed and used under normal conditions. Any product
which has been altered, including modification, misuse, accident or
lack of maintenance will not be considered under warranty. Normal
wear is excluded. The sole responsibility of Buyers Products under
this warranty is limited to repairing or replacing any part or parts
which are returned, prepaid, and are found to be defective by Buyers
Products. Authorization from Buyers Products must be obtained
before returning any part. No charges for transportation or labor per-
formed on Buyers’ products will be allowed under this warranty.

4. Remove the uprights from the trailer and use

a 13/32" drill bit to drill four holes in your trailer
deck as marked.

5. Assemble the uprights to the trailer with

four 3/8-16 x 2-1/2" cap screws, eight 3/8" flat
washers and four 3/8-16 nylock nuts. Do not
tighten screws at this time!

6. Clamp the two uprights to the rail of the

trailer. Make sure the uprights are square to the
rail and the deck of the trailer with a square.

7. With the uprights clamped into position drill

a 13/32" hole through the center of each upright
and the trailer rail.

8. Fasten each upright to the trailer rail with

a 3/8-16 x 2" cap screw, two 3/8" flat washers,
and a 3/8-16 nylock nut. Tighten all six screws.

9. Loosely assemble the top connecting angle

to an upright using hardware supplied and hold
horizontally. Mark the angle on the outside of
the second upright. Remove and cut off excess
material.

10. Drill a 13/32" hole in the center of the angle’s

web 1/2" from the end of the angle.

11. Assemble top connecting angle using two

3/8-16 x 2" cap screws, two 3/8" flat washers
and two 3/8-16 nylock nuts and tighten.