Buyers 5051210 - Manual (Page 3)

3
17. Liftgate for wiring.
a. Remove the 5/16 bolts holding the license cover. Pull out the misc parts bag/box.
b. Review the Wiring circuit in the figure below.
.25
.25
18. Install the circuit breaker on the vehicle fender,
firewall or inside the engine compartment away
from moving parts [near battery]. Make sure there
will be room for the wires to be installed and the reset
button is accessible.
19. Loosen the strain relief conduit in the back of the lift-
gate box. Pull the 4awg wire through the hole-leaving
about 2 inches of slack for easy access. Tighten the
conduit again.
20. Run the wire underneath the truck and along the frame
structure of the truck. Pull the wire beyond the battery
location
21. Split the negative and the positive wires to prepare
them for attachment to battery.
22. Cut the positive wire length needed to reach the
auxiliary terminal of the circuit breaker installed earlier.
Cut the remaining positive wire long enough to reach
from the breaker to the positive Battery terminal. Cut
the negative wire to the needed length to the battery
terminal.
23. Install the lower mount onto the frame. Remove the
slotted bracket plates from the liftgate. This is located
next to the hydraulic unit.
24. Bolt the Bracket plates to the Frame where the holes
are available (if not Drill). You may have to do simple
modification to the plates.
25. Clamp the short angle irons to the bracket plates. The
short angle acting as an extension arm to the slotted
angle irons.
26. Tackweld the bracket plates to the short angle irons;
and tack weld the short angle iron to the main long
angle iron.
27. Remove the tacked brackets by removing the bolts just
installed earlier.
28. Weld all seams with a 1/4" fillet weld.
29. Secure the Welded Brackets back onto the truck frame
and the bottom of the Lift Gate.
30. Install the license Plate onto the cover. Wiring issa not
provided for this accessory.
Fig. 8.
Fig. 9.
Weld angle to
mounting plate Weld angle
feet to main
mounting angle