Buyers 85100 - Manual (Page 2)

Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax (800) 841-8003 • buyersproducts.com
part no. qty. description
3003263 1 Protector, Rear Window (full size truck)
3002748 1 Bracket, left hand side
3002822 1 Bracket, right hand side
3003598 1 Instruction Sheet
- 8 Washer, flat 1/2"
- 2 Screw, hex head 1/2-20 x 2-1/2"
- 4 Washer, lock 1/2" split
- 2 Nut, center lock 1/2-20
3003250 2 Cushion, self-adhesive
3002723 2 Anchor
- 4 Screw, hex head 1/2-13 x 1-1/2"
- 2 Screw, hex head 1/2-13 x 4"
Bill of Materials
3003598 Rev D
Full One-year Warranty
Manufacturer will repair, or at manufacturer’s discretion will replace
any part of this Window Protector which proves to be defective in
workmanship or material under normal use for period of one year from
the date of delivery to the original purchaser. Any cost incurred in
returning the product to the supplier is the responsibility of the con-
sumer.
exclusions
Manufacturer shall not to be liable for special, incidental, or conse-
quential damages or for damages resulting from lack of necessary
maintenance, from misuse, abuse, act of God, or alteration of the prod-
uct. Some states do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitation or exclusion may
not apply to you.
Fig. 5
Fig. 4
4. If side rail covers are installed, remove protective caps
from the front stake pockets or cut openings in the rail cov-
ers to expose the front stake pockets.
If present, drill holes in bedliner walls to open access to
front stake pocket side holes. Many models of bedliners have
a small mark on a wall against front stake pocket. Use it to
drill necessary holes.
Insert anchors into stake pockets. Make sure that the
anchors’ long sides are facing inside the bed.
Align holes in anchors with stake pocket openings and
install hardware loosely from inside of the bed.
See Fig. 4
5. Position the Window Protector on the front wall of the
truck box with the “Buyers” decal facing rearward. Slide the
sides of Window Protector in the “U” shaped guides of the
brackets. Align the brackets’ slots with holes in the Window
Protector and insert 1/2-20 x 2-1/2" screws. Install lock nuts.
See Fig. 5
Position the Window Protector symmetrically on the vehicle.
Tighten lock nuts evenly on both sides with torque 60-70
foot-pounds. Tighten screws on brackets until the lock wash-
ers are flattened plus 1 - 1-1/2 turns. Overtightening these
screws can result in damage to truck’s sheet metal.
Fig. 3