Buyers P45AC6 - Manual (Page 2)

Quality since 1946
2
Fig. 1
Fig. 2
Fig. 3
3. If the space exceeds 1/2”, replace the Jaw and
Plunger Arm using replacement Jaw Kit C6200 of
the Rebuild Kit C6400.
D. Lock Inspection
1. Grasp the Lock Actuator (8) and without com-
pressing the Spring (6) rotate the Actuator handle
to lift the Lock (3) until it stops against the Body
undercut (A). The “tooth” if the Lock must not
clear the stop (B) on top of the Jaw (4). If the lock
clears the stop (B) as shown in Fig.3:
a. Inspect the undercut (A) on the Body, if the
undercut is not clean and square the entire hook
should be replaced.
b. If the under cut is in good condition, then install
a new Lock Kit C6300 or Rebuild Kit C6400.
E. Full Rebuild
If inspection steps A-D indicate that both the Lock
and Jaw mechanisms require replacement, then
the Rebuild Kit C6400 should be used.
JAW KIT C6200
In order to perfrom this repair, it will be necessary
to remove the hook from the vehicle.
A. Disassembly
1. Remove the Roll Pin (10) from the Actuator (8),
loosen the Set Screw (9) and pull the Actuator (8)
out of the assembly. This will release the Lock (3)
and the Torsion Spring (6) from the assembly.