dbx DriveRack 220i - Manual (Page 48)

44
220i
DriveRack ® User Manual
A.1 - Factory Reset/Flash Update
In the event that a reset is required, the DriveRack ® 220i offers you the option of performing a “Soft”
or “Hard” reset. The Soft Reset resets all operating parameters except user programs. The Hard Reset
Procedure will reset all programmable information back to the factory defaults.
Factory (“Hard”) Reset
• Press and hold the PROGRAM UP button on power-up until the following message appears
in the 7-Seg Display: HD”
• Pressing the LOAD button will start a Factory Reset (All User Programs will become copies
of the Factory Programs, all Utility settings will be defaulted, and all Security settings will be
defaulted) Pressing any other button will abort the Factory Reset sequence and the unit will
reset normally.
Factory (“Soft”) Reset.
• Press and Hold the PROGRAM DOWN button on power-up until the following message
appears in the 7-Seg Display: ST “
• Pressing the LOAD button will start a System Reset (All Utility settings will be defaulted.)
Pressing any other button will abort the System Reset sequence and the unit will reset normally.
Flash Update
To flash update the firmware version of the DriveRack 220i the unit needs to be put into Flash Update
Receive mode. This is done by holding the LOAD button while connecting power to the unit. Once in
Flash Update Receive mode it is ready to receive the new firmware.
Appendix