dbx DriveRack 220i - Manual (Page 12)

8
220i
DriveRack ® User Manual
1.3 - Connections
• When setting up the DriveRack 220i, make connections as follows:
• Always make connections prior to applying power to the unit.
• Connect the output from the sending device (mixer) to either of the two XLR input connectors
shown below.
• Make output connections from any one of the 2 output XLR or Euroblock connectors shown
below to the input of the selected power amps.
• It is recommended that the power amps are turned off prior to cycling power to the DriveRack
220i. Always make sure that your power amps are the last item turned on and the first turned
off.
Once all of the connections have been made and the unit is powered up, you can navigate through the
entire signal path of the DriveRack 220i from the included DriveWare GUI. The display provides you
with a clear and concise overview of each aspect of the signal path from the input to the output section.
1.4 - PC GUI Installation
Minimum System Requirements
• 266MHz processor
• Windows 98 edition 2 or Windows NT 4.0
• 16 bit color
• 64 meg RAM
Installation
• Install DriveWare from the included CD ROM or download DriveWare from the dbx website
at www.dbxpro.com.
• After clicking on the “.exe” install file, follow the instructions in the installer. The application
will proceed to prompt you for the installation location.
• Once the software installation is complete, it is recommended that you restart your computer.
Getting Started
Section 1