dbx DriveRack 220i - Manual (Page 34)

30
220i
DriveRack ® User Manual
Overshoot 1-6
This parameter sets the amount of overshoot for the Instantaneous Transient Clamp™.
3.14 - Delay
The parameters for the delay are as follows and are user adjustable:
Delay On/Off
Turns the delay on and off.
Length
Sets the amount of delay time.
Units - Seconds, Feet or Meters
Selects the unit of measurement for the delay.
3.15 - Output
The output section 220i DriveRack provide the user with the ability to control output levels of the
unit and adjust phase compensation of loudspeakers within the signal path. The output level control is
located in the signal path before the compressor/limiters; this means that the compressor/limiter directly
affects the output level. The parameters for the Phase Compensation effect are as follows and are user
adjustable.
Polarity/Phase On/Off
This parameter is used to turn the selected output phase and polarity on parameters on or off. When off,
the phase is 0
0 and polarity is positive.
Detailed Parameters
Section 3