R&M Materials Handling MANUAL CHAIN HOISTS - Manual (Page 69)

RPT / RPTC INSTRUCTION MANUAL/EN/06.17.09
7/10
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret
that may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2009) R&M Materials Handling, Inc. All rights reserved.
5 DO’S AND DON'TS
5.1 DO’S:
5.1.1 General
Read the manual carefully and always follow its recommendations. Only use "original parts" when repairing
or maintenance. Keep this instruction manual near the equipment and readily available to the operator and
the maintenance mechanic at all times.
5.1.2 Handling / Storage
•
Handle the equipment by its structure either using the fittings provided for this purpose or in its
original packaging.
•
Store the equipment in a non-aggressive environment away from sources of dust or dampness etc.
•
Regularly clean and protect from corrosion (oiling etc.).
5.1.3 Installation / Maintenance / Servicing
• Have the equipment installed by mechanically competent and trained personnel.
•
Ensure that safety regulations are complied with (safety harness, evacuation of work areas, warning
signs, etc.).
•
Verify the strength of the structure to which the equipment is to be attached.
• Carefully follow the installation instructions provided in the equipment's instruction manual.
•
Ensure correct trolley wheel spacing relative to the rail being used.
• Carry out regular maintenance of the equipment in accordance with the instruction manual.
•
Establish an inspection program and record details of all maintenance work carried out, particularly
with regard to the end stops, the suspension crosspiece, etc.
•
Replace any worn or suspect parts.
• Verify that all safety items are in good working order (end stop, etc.) in accordance with the
instruction manual.
• Regularly check the equipment.
•
If any distortion or abnormal wear is observed, the parts concerned must be replaced.
• Periodically check tightness of bolts and locking cotter pins.
5.1.4 During Use
Before any maneuver, ensure that the load is adequately secured.
Balance the load correctly before moving it.
Do not side pull the load.
Be aware of the safety rules to be observed during the various maneuvers.
Operate the equipment in normal conditions of use (ambient temperature, atmosphere,).
Equipment used outside should be adequately protected against the weather.
Inform a competent person following any dangerous or doubtful operation of the equipment (strange
noise, abnormal behavior, etc.).