Ac b – Peerless-AV VPM45-J - Installation User Manual

Page 2

SSUED: 5-25-95 SHEET #081-9002-5 09-10-04

Visit the Peerless Web Site at www.peerlessindustries.com

For customer service call 1-800-729-0307 or 708-865-8870.

2 of 2

Insert four carriage bolts (A) into slots in upper VCR
Mount. Attach lower VCR Mount using four nuts (B) and
four washers (C). HAND TIGHTEN ONLY.
Note: if adhesive pads on VCR Mount are covering
slots, trim away excessive pad to expose slots.

Insert VCR into upper VCR Mount.

Align front of VCR with front of TV on TV Mount
above (TV Mount not pictured). Tighten expansion
screws in sides and bottom of VCR Mount to
clamp the VCR with a firm, secure grip.

Note: To access the vertical expansion screws
located on the bottom of the upper VCR Mount,
slide the lower VCR Mount to the side exposing
vertical expansion screw. Repeat this step on
opposite side of VCR Mount. Center lower VCR
Mount and tighten four nuts (B, see step 3)
securely.

Expand lower VCR Mount to slightly larger than
the height and width of the VCR that it will hold.
Insert and clamp lower VCR into lower VCR
Mount.

OPTIONAL: If attaching multiple VCR mounts to a TV mount, proceed with step 3 through 5.

IMPORTANT! Do not stack more than three VCR Mounts from a single Peerless TV Mount!

IMPORTANT! Stacked load can not exceed 50 lb.

adhesive pad

slots

Peerless and Jumbo are registered trademarks of Peerless Industries, Inc.

All other brand and product names are trademarks or registered trademarks of their respective owners.