Peerless-AV DS45 - Installation - Manual (Page 2)

2 of 3 ISSUED: 5-25-95 SHEET #: 081-9001-4 06-08-11
Visit the Peerless Web Site at www.peerlessmounts.com For customer service call (800) 865-2112
A
C
Adjust height + width.
Mount VCR.
Attach foam pads ( A)
and ( C) as shown.
M
N
D
B
L
This VCR mount can be used with two different types of TV mounts/stands. As a result, you will not use all of
the fasteners provided. Follow the instructions for the type of TV mount/stand you have.
All other parts shown are found with TV mount/stand.
I
f you have the TV mount/stand pictured below and the mount is
already assembled, it will have to be disassembled to do this instal-
lation.
Assemble the
parts as shown.
1
1
2 3
Use parts L, N, & M for this installation.
TV does not need to be removed for this installation.
Assemble the
parts as shown.
There are two small holes, on the bottom of the bar that runs
underneath the tray. If you do not see them, the bar was probably
installed upside down when the TV mount/stand was assembled. You
will need to remove the tray and the bar to turn it around so that the
holes face downward.
IMPORTANT: Be sure to reuse carriage bolt, brass washer
and lock nut included with wall mount.
CARRIAGE BoLT
BRASS WASHER LoCk NUT