Peerless-AV GC-PS3S - Installation - Manual (Page 7)

7 of 7 ISSUED: 1-17-11 SHEET #: 125-9181-1
Figure. 1.2 Figure. 1.3
BOTTOM OF MOUNTING SURFACE
B
F
G
F
F
B
Figure. 1.4
TIGHTENING
SLOPE NUT
Desktop Mounting Surface Lock down Installation
1
© 2011 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc. Other parties’ marks are the property of their respective owners.
Figure. 1.1
TOP OF MOUNTING SURFACE
B
A
J
PlayStation ® 3
Place lock down plate ( A) onto mounting surface as a template. Level, and mark the center of four rectangular
mounting holes. Drill four 5/16” (8 mm) dia. holes through desktop mounting surface. Secure using four carriage
bolts ( B) though lock down plate (A) and mounting surface as shown in figure 1.1.
Secure two 1/4-20 x 1 3/4” carriage bolts ( B) using two 1/4-20 nylock nuts (J) in corners as shown in figure 1.1.
Using remaining 1/4-20 x 1 3/4” carriage bolts ( B), hand tighten slope nut (F) through 1/4-20 x 1 3/4" carriage bolt
( B) until snug against bottom of desktop surface as shown in figure 1.2. Thread another slope nut (F) upside-down,
about two turns from first slope nut ( F). Insert a open box wrench between both slope nuts (F) and tighten.
NOTE: Avoid jamming both slope nuts (F) together, doing so may make it difficult to remove slope nut used for
tightening first slope nut ( F) as shown in figure 1.3. After slope nut is secure remove bottom slope nut and add
plastic cap ( G) as shown in figure 1.4. Repeat with remaining 1/4-20 x 1 3/4" carriage bolt (B).