PowerWalker ViewPower PowerWalker User Manual

Page 30

Step 2

Select a specific event from “Event List” and then action method page will be

active on the right-hand column.

Step 3

Select desired action methods by clicking checkbox.

Step 4

Click “Apply” button to save all configurations.

NOTE1: When editing receiver list in SMS or e-mail columns, it’s necessary to

refresh the event action page to reload the updated receiver list.

NOTE2: It is requested to have following conditions for successful broadcast.

All receiving PCs must have installed software.

Only send the message to the PCs in LAN found in UPS Navigation.

5.1.5.

Wake on LAN

It will manage the list for wake on LAN and test the function.

After adding MAC address of remote PCs into MAC list, it will allow remote control the

PCs. However, it’s also required to have hardware support for remote PCs to implement

this function.

Step 1

Select ViewPower Configuration >> Wake on LAN. Refer to Diagram 5-7.