PowerWalker ViewPower PowerWalker - Manual (Page 14)

13
If port conflict occurs, you may modify value of tray port. The default setting for
tray port is listed as below (Refer to section A in Diagram 3-1):
Web Service port: 15178
Web service shutdown port: 8005
AJP port: 8009
You may modify the value of tray port to any number between 0 to 65536. If
value entry is used, the system will remind users to enter another number
again.
NOTE1: Please do NOT modify port value unless port conflict occurs. This
modification will affect remote monitoring website. For example, if changing web
service port to 15177, then the remote monitoring website will change to
：
http://xxx.xxx.xxx.xxx:15177/ViewPower
NOTE2
： ： ： ：
To avoid possible conflicts, please do NOT enter value with less than 4
digits.
3.3.2. ViewPower Start And Exit Setting
Refer to section B in Diagram 3-1 for the detailed configuration of ViewPower
start and exit setting:
Server startup type: If “Auto” is selected, the software will automatically
start up when PC is turned on. If “Manually” is selected, users have to
manually start the ViewPower software.
Exit to stop monitoring: If selected, it will completely exit software without
monitoring service. If unselected, it will continue monitoring service in the
back end even though exit from software.
3.3.3. Software Upgrades
Refer to section C in Diagram 3-1 for the detailed configuration for online
upgrade:
Specify the URL for update files: This is the directory to online update
software. Please do not change it unless it’s instructed by software vendor.