Peterson Sonuus Wahoo - Manual (Page 26)

26 © Copyright 2012 Sonuus Limited Wahoo
Owner’s Manual
MIDI
input (from computer to Wahoo)
Battery monitoring
When the battery level is getting low, bAt will periodically appear on the display to warn you.
To see the estimated percentage of battery life remaining, simultaneously press and hold the FILTER
button and the S S S S button. When using batteries, it is a good idea to check the remaining battery
capacity before a performance so that you can replace/recharge the batteries if required.
Note that when
DC or USB power are available, the displayed battery level will not show the correct
value, but will instead show a value related to the available supply voltage. This is because when an
alternative power supply is available, the batteries are disconnected to prolong their life.
MIDI
message Chan a
a. Channel F(0,1): Channel 0 = Filter1, Channel 1 = Filter2.
Description
MIDI sync
MIDI clock
N/A Used when LFO is in MIDI sync ( Syn) mode.
Song position
Program Change
Program Change omni
Selects the preset to be used. Operates on the currently
selected bank (factory or user). Use Bank Select
controller message to switch between factory and user
banks.
Controllers
MSB LSB
Bank Select #0 #32 omni
Selects factory (0) or user (1) preset bank.
(Factory: #0=0, #32=0. User: #0=0, #32=1.)
Expression #11 #43 F(0,1)
Controls filter in pedal (CtL) mode.
The controller works just like a remote footpedal.
Cutoff #74 — F(0,1) Controls filter in pedal (rEM) mode.
Cutoff moves filter between freq-lo and freq-hi
Resonance sets the Q from 0 to 100.
( Q-lo and Q-hi are not used in this mode.)
Resonance #71 — F(0,1)
Note messages
Note-on F(0,1)
Controls filter in pedal (not) mode.
The filter cutoff is set to the frequency of the note within
the limits set by freq-lo and freq-hi.