Owner’s manual, Adjusting, Mode – Peterson Sonuus Wahoo User Manual

Page 18: Pedal mode, Wahoo

Wahoo

Owner’s Manual

Adjusting

MODE

The

MODE

controls of the Wahoo work slightly differently from the

LEVEL

and

FILTER

controls

described above. Each of the two filters has one mode, selected from

pedal,

LFO

envelope or pitch,

and the mode for each filter can be different. Configure each filter separately, switching between
them using the

FILTER

button. For each filter, press the

MODE

knob to cycle through the modes,

stopping on the operating mode you want for this filter. Use the S

buttons to cycle through the

sub-parameters for this mode and turn the

MODE

knob to change the values of the sub-parameters.

You do not need to set up values for the sub-parameters of the other modes for this filter—you only
set up the single mode that you have selected for this filter.
When both filters are in the same mode they can work together to create thick, vocal tones. When
the filters are in different modes you can get new interesting effects.
Note: the custom parameters are covered later in this manual (see “Custom settings” on page 27).
They operate separately from the four modes described above.

Pedal mode

If you select

pedal mode for a filter, you can select standard wah pedal operation or

MIDI

-controlled

operation by setting the value of the

pedal parameter as described in the following table. For details

MIDI

operation, refer to

“

MIDI

operation” on page 25.

Pedal parameter value

Description

PEd

pedal: The Wahoo footpedal controls the filter: standard wah pedal mode.

CtL

control:

MIDI

expression controller (14-bit) controls the filter.

rEM

remote:

MIDI

cut-off and resonance controllers (7-bit) control the filter.

not

note:

MIDI

note controls the filter.