Owner’s manual, Creating your own presets, Wahoo – Peterson Sonuus Wahoo User Manual

Page 12: Creating and saving a user preset, Selecting and changing parameters

Wahoo

Owner’s Manual

Creating your own presets

You can create and store up to 100 user presets on the Wahoo. The steps for creating a preset are
straight-forward.

Creating and saving a user preset

Ensure that the

LOCK

switch is in the unlocked position. Starting from any preset (factory or

user), adjust the Wahoo

settings using the

LEVEL

FILTER

and

MODE

knobs to get the desired

musical effect. These settings are discussed in detail later.

Save the preset. Press the

save button. Use the S

buttons to select a user preset

number (

P00–P99) where you would like to store your preset. The name of the existing

preset (if any) flashes alternately with the preset number to help you select either an

unused preset or a preset to overwrite. Press the

save button again when you have

selected your preset number. You can now edit the three-character preset name. Using any

one of the three knobs (

LEVEL

FILTER

MODE

) turn the knob to cycle through A-Z, 0-9 and

press a knob to advance to the next of the three characters in the preset name. Finally,

press the

save button to write your preset to the chosen location.

The

save button flashes while this save process is in progress. To abandon the save at any

time, and revert to Preset Select mode, press and hold the

save button for 2 seconds.

Selecting and changing parameters

When you press the

FILTER

button, or press or move a knob (

LEVEL

FILTER

MODE

), the

Wahoo will enter Preset Edit mode. The flashing

LED

shows which parameter is being

displayed on the numeric display. Pressing a knob will let you select another parameter to

be edited. For example, successive presses on the

LEVEL

knob will cycle between editing

drive, filt mix 1/2, dry/wet and output.

Change the value of a parameter by turning the knob next the that parameter’s

LED

. When

you have the value that you want for that parameter, select another parameter to edit.

When you have completed your editing, you can save your setup as described previously.

Some parameters have sub-parameters. For these, the S

buttons will also flash. Cycle

round the sub-parameters using the S

buttons. The name of the sub-parameters is

shown on the display to make it clear what is being selected for editing. Turn the knob to

change the value of the sub-parameter that is being edited.

All of the filter parameters and the mode parameters can be set independently for each of

the two filters. Select which filter to edit by using the

FILTER

button to switch between filter 1

and filter 2. The filter whose settings are being altered is indicated by the illuminated filter

LED

(

1 or 2).