B&B Electronics VESR321_ML_SL - Manual - Manual (Page 17)

Setup and Connections
www.bb-elec.com
www.bb-europe.com
13
Figure 14. Paired Mode Setup
To set up a Paired Mode connection:
1. Connect two serial servers to serial devices and to the network.
2. Configure the serial server for Paired Mode operation (using Vlinx Manager or the web
interface).
Initiating a Hardware Reset on the Serial Server
To initiate a Hardware Reset on the serial server, press and hold the Mode switch for 0 to 2
seconds, and then release it.
The device will reset. When finished, the Ready LED will be blinking.
Reloading Factory Defaults
To reload Factory Defaults, press and hold the Mode switch for more than 10 seconds, then
release it.
The serial server will reload all factory default configuration parameters. When finished, the
Ready LED will be blinking.
Note: Factor default parameters are listed in Appendix A