B&B Electronics ISOCON-6 - Manual - Manual (Page 7)

ISOCON-6 USERS GUIDE
4.1.2 Current Input
Select the range from the table below and set Switch S1 to the required values.
mA Range
1 2 3 4 5 6 7 8 9 10 11 12
0-1mA 0 0 0 0 0 0 0 0 1 1 1 0
0-2mA 0 0 0 1 0
0-4mA 0 0 1 0 0
0-5mA 0 1 0 0 0
0-8mA 0 0 1 1 0
0-10mA 0 1 0 1 0
0-15mA 1 0 0 1 0
0-20mA 0 1 1 0 0
0-30mA 1 0 1 0 0
4-20mA 0 1 1 0 1
4-40mA 0 1 1 1 1
4-30mA 1 0 1 0 1
-5 to +5mA 1 1 0 0 1
-10 to +10mA 1 1 0 1 0 0 0 0 1 1 1 0
Switch S1
Then select the required setting from the table below for switch S2
mA Range
1 2 3 4 5 6 7 8 9 10 11 12
1 1 0 1 0 0 1 1 0 0 1 0
1 1 0 0 0 0 1 1 0 0 0 0
1 1 0 0 1 0 1 0 0 0 0 0
Bipolar Ranges
(e.g.
-10 to +10mA)
Using Internal 24V
Tx Supply for
4 to 20mA
Unipolar Ranges
(e.g. 0-20mA,
4-20mA)
Switch S2
Please note that PC Software is available to provide information on
switch settings for your input and output requirements.
! WARNING !
DO NOT OPEN UNIT OR ADJUST SWITCHES WITH
POWER SUPPLY, INPUT OR OUTPUT CONNECTED
!
IIG-010801 Page
7