B&B Electronics ISOCON-6 - Manual - Manual (Page 11)

ISOCON-6 USERS GUIDE
4.1.6 RTD Input
Select the range from the table below and set Switch S1 to the required values.
Range in °C
1 2 3 4 5 6 7 8 9 10 11 12
0 to 100 0 0 0 0 0 0 1 0 0
0 to 200 0 0 0 1
0 to 400 0 0 1 0
0 to 800 0 0 1 1
-50 to 50 0 1 0 0
-50 to 150 0 1 0 1
-50 to 250 0 1 1 0
-50 to 350 0 1 1 1
-100 to 50 1 0 0 0
-100 to 100 1 0 0 1
-100 to 200 1 0 1 0
-100 to 400 1 0 1 1
-200 to 200 1 1 0 0
-200 to 400 1 1 0 1
-200 to 600 1 1 1 0
-200 to 800 1 1 1 1 0 0 1 0 0
RTD linearisation ON 0 PT100 0
RTD linearisation off 1 PT1000 1
RTD 2 or 4 wire 0
RTD 3 wire 1
Switch S1
And then select the required setting from the table below for switch S2
RTD
1 2 3 4 5 6 7 8 9 10 11 12
2 Wire RTD 0 1 0 0 1 0 0 1 0 0 0 1
3 Wire RTD 0 1 0 0 0 0 0 0 1 0 0 1
4 Wire RTD 0 1 0 0 0 0 0 1 0 1 0 0
Switch S2
!
! WARNING !
DO NOT OPEN UNIT OR ADJUST SWITCHES WITH
POWER SUPPLY, INPUT OR OUTPUT CONNECTED
Please note that PC Software is available to provide information on
switch settings for your input and output requirements.
IIG-010801 Page
11