RocketFish RF-TVML70 - User Manual - Manual (Page 17)

17 Need help? Call 800-620-2790
RF-TVML70 TV Wall Mount
STEP 10 - Adjusting the vertical motion and tilt
Important! You will need to adjust this product after installation is complete.
Make sure all your equipment is properly installed on the product before adjusting. This product should move
smoothly and easily through the full range of motion and stay where you set it. If movements are too easy or diffcult or
if product does not stay in desired position, follow the adjustment instructions to create smooth and easy movements.
NOTE: Depending on your product and the type of adjustment, it may take many turns to notice a difference.
Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load,
you should repeat these adjustment steps to ensure safe and optimum operation.
1 To increase or decrease the lift tension setting, use the socket wrench w/13 mm socket.
2 Loosent the tilt adjustment knob, then tilt the TV to the angle you want. Retighten the tilt adjustment knob.
You can adjust the tilt up to 10° forward.
For customer service, call: 800-620-2790 (U.S./Canada markets)
You’ll need
1
Up to 16”
Increase
If TV weight exceeds product’s factory setting, it
won’t stay up when raised. To prevent TV from
sagging downward, increase tension setting.
Adjusting the factory-set tension
Decrease
If TV weight is lower than product’s factory
setting, it won’t stay down when lowered. To
prevent TV from drifting upward, decrease
tension setting.
2
Up to 10°
Socket wrench w/13 mm socket
RF-TVML70_13-0455_MAN_V3_ENG.fm Page 17 Monday, May 6, 2013 7:45 AM