Turbosmart BOV ADAPTERS - Toyota Supra – Twin Turbo - Manual

SUPRA JZA80 TWIN TURBO BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia Ph: +61(2) 9798 2866 Fax: +61 (2) 9798 2826 Email: [email protected]
USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA Ph: (760) 727 7610 Fax: (760) 727 7963 Email: [email protected]
PART NUMBER
FG-ADM-SUPRA
IMPORTANT NOTES ON FITTING YOUR SUPRA TWIN TURBO ADAPTOR
Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.
ADAPTOR KIT CONTENTS
Please check that the following items have been supplied in your Supra Twin Turbo Adaptor Kit.
Quantity Description Use
1 Supra TT adaptor pipe Joining pipe from the intercooler to the throttle body
2 90mm hose clamps Secures the adaptor pipe to the throttle body
1 70mm hose clamps Secures the adaptor pipe to the intercooler pipe
1 75mm ID Silicon hose coupler To connect the adaptor pipe to the throttle body
1 Pre-assembled Silicon hose assembly Connects the vacuum/boost source to the Turbosmart BOV
1 5mm spring clamp Secures the 5mm Silicon hose to the Turbosmart BOV
1 6mm spring clamp Secures the 6mm Silicon hose to the factory vacuum/boost source
2 19mm blanking plug To block off the factory boost pipe and return pipe
1 250mm long cable tie To support the radiator hose by securing it to the BOV
2 150mm long cable tie To support the vacuum/boost hose by securing it to radiator hose
Note: The Supra TT pipework adaptor kit readily accepts the following Turbosmart BOVs:
Blow Off Valve Name Part No.
Blow-off Valve - Vee Port FG-BOV-002VP
Blow-off Valve - Supersonic FG-BOV-003SS
Blow-off Valve - Megasonic FG-BOV-003MS
To install a Dual Port or Plumb Back BOV, fabrication will be required to connect the plumb-back fitting to the intake.
FITTING YOUR SUPRA TWIN TURBO BOV ADAPTOR
Note: Please thoroughly read and understand both these instructions and the fitting instructions supplied with your
BOV before commencing this installation.
Step 1. Locate the factory BOV and factory intercooler
outlet pipe.
Step 2. The intercooler inlet pipe needs to be removed
to access the factory BOV. Loosen the two hose
clamps securing the intercooler inlet pipe with a Philips
head screwdriver or 10mm socket.
Factory BOV
Factory Intercooler Outlet Pipe
Factory Intercooler Inlet Pipe