Daystar KCO9106 - Manual (Page 2)

Thank you for choosing Daystar Products
Daystar recommends a certified technician install this system. In addition to
these instructions, professional knowledge of disassembly/reassembly proce-
dures as well as post instructions checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integ-
rity and/or operating of the vehicle.
Please read all the instructions before beginning the installation. Check the
kit hardware against the parts list. Be sure you have all the needed parts and
understand where they go. If anything is missing, do not proceed with the
installation, call Daystar Products to obtain any needed items.
Product Use Information
As a general rule, the taller a vehicle is the easier it will roll. We strongly rec-
ommend, because of rollover possibility, that seat belts and shoulder har-
nesses be worn at all times. Avoid situations where a side rollover may occur.
Braking performance and capabilities are decreased when significantly large/
heaver tires and wheels are used. Take this into consideration while driving,
Also, speedometer recalibration is necessary when larger tires are installed.
Do not add, alter, or fabricate any factory or after-market parts which increase
vehicle height over the intended height of the Daystar Product purchased.
Mixing component brands, lifts, and/or combining body lift with suspension
lift voids all warranties. Daystar makes no claims regarding lifting devices
and excludes any and all implied claims. We will not be responsible for any
products that is altered.
Notice to Dealer and Vehicle Owner
Any vehicle equipped with any Daystar Product must have the “Warning to
driver” decal installed on the sun visor or dash. The decal is to act a constant
reminder for whoever is operating the vehicle of its unique handling charac-
teristics. INSTALLING DEALER— Its is your responsibility to install the
warning decal and forward these instructions on to the vehicle owner for re-
view and to be kept in the vehicle for service life.
After installation occurs, a qualified alignment facility is required to align the
vehicle to factory specs.
IMPORTANT NOTE: The advertised amount of lift that this kit provides and the thickness of
the spacers supplied will not be the same! For example, a 2-1/2” lift may only have 1-1/2”
thick spacers. The reason for the difference between the spacer thickness and the amount of
lift has to do with suspension geometry. There is a ratio involved, and it is this ratio that
determines the thickness of the spacers. Rest assured, installing the spacer supplied will result
in the proper amount of lift out at the wheel.
44. Start the vehicle and check and see that every thing is working
correctly.
45. Alignment must be performed by a certified professional.
46. Max tire size is a 31” tire overall diameter.
AFTER BEFORE