Daystar KN09106 User Manual
Step(s)
KN09106 KN09107 – Nissan 2004-2012 Front 2 ” Lift
Instruction Sheet P11079-1
2010 Daystar Products International Inc.
www.DaystarWeb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
Step(s)
1.
Layout all parts and check quantities against the Bill of Materials. Completely read
instructions before beginning installation.
2.
Do not install the kit on another lift or altered suspension.
3.
Jack the front of the vehicle in accordance to manufacturer recommendation and
support with jack stands, so that the front two tires are off the ground
4.
Remove the front tires/wheels.
5.
Remove sway bar end link.
6.
Remove upper ball joint nut and remove spindle from upper A-arm.
7.
Remove upper strut nuts on the strut tower (3) on each side of vehicle that holds strut
assembly to the strut tower (Hint: Leave one nut on to prevent the strut from dropping
out in the next step.)
8.
Remove lower strut bolt from the lower control arm and remove the strut assembly from
vehicle. (Note the direction of the bolt for reinstallation) (Figure 1)
9.
Install the 3 stud extenders with the M20463 spacer on top of strut assembly.
10. Install the strut assembly into the strut tower and start the upper three 10mm nuts & washers. (Make sure that the bottom of
the strut is aligned as well)
11.
Install the lower strut bolt in the original position that it was removed.
12.
Using the floor jack, raise the lower control arm and connect the upper ball joint on the upper control arm to the spindle.
Torque per OEM specifications.
13.
Reconnect the sway bar end links. Torque per OEM specifications.
14.
Install the front tires/wheels.
15.
Lower the vehicle onto the ground and tighten the upper strut tower nuts. (3 on each side).
16.
Torque all bolts to factory specifications.
17.
Have wheel alignment done after installation.
18.
Re-torque all bolts after 500 miles.
Figure 1
Tools required
Description
Qty.
Wrench set & Socket set
1
Floor Jack
1
Jack Stand
2+
Bill of Materials
Part #
Description
Qty
M20463
Top spacer
2
S11134
Stud extender
6
S10518
10mm-1.25 lock nut
6
S10077
WASHERS
6