Daystar KJ09116BK-2 - Manual

Jeep KJ Liberty 2002-2006
2” Rear Coil Spring Spacers
Instruction Sheet P10537-01
© 2006 Daystar Products International
www.DaystarWeb.com
Tech Support Contact Info
[email protected]
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71 st Avenue
Phoenix, AZ 85043
Bill of Materials
Part No. Description Qty
M03324 Coil Spacer R 2
M00337 Shock Boot R 2
P01055 Cable Ties 2
NOTE: SEE WARNING AT BOTTOM
OF PAGE.
DO NOT COMBINE WITH ANY OTHER
SUSPENSION KIT
Fig. 1
Rear Installation Instructions
1. Raise the rear of vehicle and support with jack stands in front of the lower control
arms so that the rear tires are off of the ground. Remove the rear wheels.
Fig. 2
2. With a floor jack supporting the axle, disconnect the upper shock mounts. Figure 1.
3. Lower the axle and remove the coil springs. Figure 2.
4. Remove the lower coil spring isolator. Figure 3.
5. Install the coil spring spacer in the same position as the lower isolator. Figure 4.
6. Install the coil spring on top of the coil spring spacer. (You may have to use a coil
spring compressor to reinstall the coil spring) Figure 5.
Fig. 3
7. Raise the floor jack and reconnect the upper shock mounts and torque all bolts to
factory specs.
8. Reinstall the wheels and lower the vehicle to the ground.
9. Recheck all bolts after 500 miles.
10. Upon completion of kit installation the following warning applies :
Fig. 4
WARNING
This vehicle has been modified to enhance its performance. The steering, braking and handling
of this vehicle will differ from standard passenger cars and trucks, This vehicle handles differently
from an ordinary vehicle in driving conditions which may occur on streets, highways and off road.
Avoid unnecessary abrupt maneuvers, sudden stops, sharp turns and other driving conditions
that could cause loss of control, possibly leading to a roll over or other accident that could result in
serious injury or death to driver and passengers.
If larger tires are installed the speedometer will read lower than the vehicles actual speed.
DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES.
This kit should be installed by a professional mechanic
Fig. 5