beautypg.com

Daystar KF09050 User Manual

Daystar For the car

background image

KF09050BK Coil Spring Spacer Kit with Stud Extenders & Shocks
1999-2011 F250, F350 – 2WD

www.DaystarWeb.com

Tech Support Contact Info

[email protected]

Phone: 623.907.0081

Fax: 623.907.0088

841 South 71

st

Avenue

Phoenix, AZ 85043

Instruction Sheet P20449

Page

1 of 2

2006 Daystar Products International Inc.

Fig. 6

Fig. 5








1. Read complete instructions and check Bill of Materials before

beginning.

2. Raise the front of the vehicle and support the frame so that the front

tires just touch the ground and remove the front tires.

3. Remove the front shocks and the lower sway bar end link attaching

points.

4. Remove the upper and the lower coil spring clamp bolt and nut with

washer. See figure 1 and 2.

5. Force the axle half down so that the coil spring comes loose.
6. Remove the coil spring and the coil spring rubber isolator. See figure

3.

7. Install the corresponding Stud Extensions (if needed) onto the coil

spring lower clamp stud and install the coil spring spacer onto the
coil spring pad. See figure 4.

8. Install the coil spring onto the coil spring spacer and then into the

frame. You may have to use a coil spring compressor. See figure 5.

9. Install the upper and the lower coil spring clamp bolt and nut with

washer. Make sure that the coil spring is seated correctly into the upper
frame. See figure 6 and 7.

10. Reconnect the sway bar end link attaching points.
11. Assemble the bushings, sleeves, and shock boots for the front shock

absorbers. Use the factory hardware at the bottom and the supplied
hardware at the top..

12. Torque all bolts and nuts to factory specifications. Re-torque all bolts

and nuts after 500 miles.

13. Install front tires and remove the jack stands. Lower the vehicle onto

the ground.

14. On the rear, remove the factory shock absorbers but save all

hardware for re-use.

15. Assemble the bushings, sleeves, and shock boots for the rear shocks. Install them using the

factory hardware.

16. It is recommended that you have a front-end alignment.

Bill of

Materials

Part Number

Quantity Description

M03299-BK-
01

2

Coil spring spacer

S10559

2

Stud Extension

H7054S

2

Front shock

H7053S

2

Rear shock

BU01004

1

Hardware bag, front shocks

BU01014

1

Hardware bag, rear shocks

NOTE: If your vehicle has factory 2 ½” studs

holding the coil spring onto the axle assem-
bly, you will not need to use the stud exten-
sions.

Fig. 1

Fig. 7

Fig. 4

Fig. 3

Fig. 2