Grain Systems Bin Accessories PNEG-1096 - Manual (Page 61)

61 PNEG-1096 Ladder, Safety Cage, & Platforms
4.00 OUTSIDE STIFFENED
LS-4353 SAFETY CAGE
44" VERTICAL SUPPORT
EXTENSION ANGLE
LS-5286 (FL. GREEN)
SAFETY CAGE PLATFORM
LS-4349 SAFETY CAGE
STANDARD BRACKET
LS-4353 SAFETY CAGE
44" VERTICAL SUPPORT
LS-4351 SAFETY CAGE
HOOP HALF
Whereas you formerly had all extension packages
bundled and listed under the LS-4365LB part number
you will now have a combination of LS-4366LB
(A package of two (2) extension kits) and LS-4365LB
(The original single extension kit).
VERTICAL SUPPORTS
After all three hoop assemblies are in place you
may attach the 44" vertical supports from hoop
assembly to hoop assembly, as shown. This will
require 14 supports, 7 between each set of hoops.
Bolts should have the head of the bolt to the inside
of the safety cage.
SAFETY CAGE
Attach the vertical support pieces to the existing
hoop halves above using the 5/16" x 3/4" bolts
and nuts (with the heads on the inside of the cage).
Fasten two hoop halves together and to the safety
cage brackets. Bolt the safety cage brackets to the
ladder, the supports to the hoop halves and tighten
bolts. Continue in the same manner.
44" SAFETY CAGE BELL SECTION
The safety cage bell section is to be used at the
point of termination of the safety cage just above
the concrete or platform (generally 7 to 8 feet).
Attach the vertical supports to the existing hoop
halves. Attach the special bell safety cage hoop
halves to the brackets and attach to the vertical
supports. Fasten the safety cage brackets to the
ladder (some field drilling may be required).
Tighten all bolts at this time. The vertical supports
will have to be bent at the flat area to allow for tne
angle of bell section.
LS-4353 SAFETY CAGE
44" VERTICAL SUPPORT
LS-4352 SAFETY CAGE
BELL HOOP HALF REV. 926/01
LS-6697