Grain Systems Bin Accessories PNEG-1096 - Manual (Page 15)

15 PNEG-1096 Ladder, Safety Cage, & Platforms
2.66 INSIDE STIFFENED
LS-4353 Safety Cage
44" Vertical Support
REV. 9/14/01
EAVE SAFETY CAGE
After all three hoop assemblies are in
place you may attach the 44" vertical
supports from hoop to hoop. This will
require 10 supports, 5 between each
set of hoops. Again use the truss
head bolts with bolt head to the inside
of safety cage.
WHEN ATTACHING SAFETY CAGE TO PLATFORM, THE HOOP ADJUSTER PLATE MUST BE USED
TO COMPENSATE FOR THE DIFFERENT BIN CURVATURES. NOTE: (THIS PLATE IS NOT NEEDED
FOR 90' & 105' DIAMETER BINS.) BOLT THE PROPER END TO THE EXTENSION ANGLE OR ADAPTER
HOLE. NOW LOCATE PROPER HOLES IN HOOP ADJUSTER PLATE AND BOLT TO THE SAFETY CAGE
ADAPTER HOOP.
12'-15' 21'-24'
18' 30'-33'
27' 36'-42' 48' 75'-78'
72' 60'
BOLT TO
EXTENSION
ANGLE OR
ADAPTER
ANGLE
LS-4353 Safety Cage
44" Vertical Support
LS-6697 Safety
Cage Platform
Extension Angle
SAFETY CAGE EXTENSION
The safety cage extension package is designed to be
added on to the bottom of the existing safety cage above
it. Attach the vertical support pieces to the existing hoop
halves above using the 5/16" x 3/4" bolt and nuts. Fasten
the package to the safety cage brackets and attach the
bottom of the vertical supports to the hoop halves and
tighen bolts. Continue to use the extension packages as
the usage chart reflect on the following page.
Whereas you formerly had all extension packages bundled
and listed under the LS-4365LB part number you will now
have a combination of LS-4366LB (A package of two (2)
extension kits) and LS-4365LB (The original single ex-
tension kit).
LS-4351
Safety Cage
Hoop Half
LS-4349 Safety Cage
Standard Bracket