Grain Systems Bin Accessories PNEG-1096 - Manual (Page 37)

37 PNEG-1096 Ladder, Safety Cage, & Platforms
4.00 INSIDE STIFFENED
LADDER PLACEMENT
Ladder placement on the grain bin is very
important at this time. Refer to the diagram at
the left and follow the correct dimensions as
shown. Ladder standoff must be located 8"
below the horizontal seam. Check your ladder
to make sure the ladder rung dimples are to
the top surface. Attach ladder to the standoffs
using the holes located 6 1/4" from the end of
ladder section. Use 5/16" x 3/4" bin bolts for
these connections. Now all standoffs must be
located in horizontal seam holes (repeating
every 44") until reaching the first rest platform.
Refer to the section in these instructions that
references the location of intermediate rest
platforms for further hole locations.
Roof Sheet
Ladder Section
LDR-4002
Outside
Standoffs
LS-121
8"
8"
6.1/4"
REV.10/9/01
PLATFORM SUPPORT ASSEMBLY
Horizontal Seam
LS-6705
Mounting
Angle 35"
LS-370
Support Angle
30.3/4"
LS-369
Brace Angle
30-3/4"
When starting the platform support, you
must attach the mounting angle to the
sidewall of the grain bin. Refer back to the
first page for the correct holes to be used
by the platform. Attach the angle using
5/16" x 3/4" bolts and nuts, tighten at this
time. Next, bolt the support angle to the
mounting angle again using the proper
holes. Attach the brace angle to the
mounting angle as shown in the diagram
at left. Use 5/16" x 3/4" bolts and nuts for
all connections.
18 3/4''