Grain Systems Bin Accessories PNEG-1096 - Manual (Page 12)

12 PNEG-1096 Ladder, Safety Cage, & Platforms
2.66 INSIDE STIFFENED
LS-369
Brace Angle
30 3/4"
LADDER PLACEMENT
Ladder placement on the grain bin is very
important at this time. Refer to the diagram
at the left and follow the correct dimensions as
shown. Ladder standoff must be located
8" below the horizontal seam. Check your
ladder to make sure the ladder rung dimples
are to the top surface. Attach ladder to the
standoffs using the holes located 6 1/4"
from the end of ladder section. Use 5/16" x
3/4" bin bolts for these connections. Now all
standoffs must be located in horizontal seam
holes (repeating every 32") until reaching
the first rest platform. Refer to the section
in these instructions that references the loca-
tion of intermediate rest platforms for further
hole locations.
LS-6705
Mounting Angle 34"
Horizontal Seam
Ladder Section
LDR-4002
6.1/4"
8"
8"
Roof Sheet
Outside
Standoff
LS-121
LS-370
Support Angle
REV. 10/9/01
When starting the platform support, you
must attach the mounting angle to the
sidewall of the grain bin. Refer back to the
first page for the correct holes to be used
by the platform. Attach the angle using
5/16" x 3/4" bolts and nuts, tighten at this
time. Next, bolt the support angle to the
mounting angle again using the proper
holes. Attach the brace angle to the
mounting angle as shown in the diagram
at left. Use 5/16" x 3/4" bolts and nuts for
all connections.
PLATFORM SUPPORT ASSEMBLY
18 3/4''