Grain Systems Bin Accessories PNEG-1096 - Manual (Page 40)

40 PNEG-1096 Ladder, Safety Cage, & Platforms
4.00 INSIDE STIFFENED
WHEN ATTACHING SAFETY CAGE TO PLATFORM, THE HOOP ADJUSTER PLATE MUST BE USED
TO COMPENSATE FOR THE DIFFERENT BIN CURVATURES. NOTE: (THIS PLATE IS NOT NEEDED
FOR 90' & 105' DIAMETER BINS.) BOLT THE PROPER END TO THE EXTENSION ANGLE OR ADAPTER
HOLE. NOW LOCATE PROPER HOLES IN HOOP ADJUSTER PLATE AND BOLT TO THE SAFETY CAGE
ADAPTER HOOP.
30'-33'
27' 36'-42'
BOLT TO
EXTENSION
ANGLE OR
ADAPTER
ANGLE
EAVE SAFETY CAGE
After all three hoop assemblies are in place
you may attach the 44" vertical supports from
hoop to hoop. This will require 10 supports, 5
between each set of hoops. Again use the truss
head bolts with bolt head to the inside of safety
cage.
48' 75'-78'
72' 60'
LS-4353 Safety Cage
44" Vertical Support
LS-6697 Safety
Cage Platform
Extension Angle
SAFETY CAGE EXTENSION
The safety cage extension package is designed to be
added on to the bottom of the existing safety cage above
it. Attach the vertical support pieces to the existing hoop
halves above using the 5/16" x 3/4" bolt and nuts. Fas-
ten the package to the safety cage brackets and attach
the bottom of the vertical supports to the hoop halves
and tighen bolts. Continue to use the extension pack-
ages as the usage chart reflect on the following page.
Whereas you formerly had all extension packages
bundled and listed under the LS-4365LB part number you
will now have a combination of LS-4366LB (A package
of two (2) extension kits) and LS-4365LB (The original
single extension kit).
LS-4351
Safety Cage
Hoop Half
LS-4349
Safety Cage Standard
Bracket
LS-4353 Safety Cage
44" Vertical Support
REV. 9/25/01