Grain Systems Bin Accessories PNEG-1451 - Manual (Page 79)

7. 4.00" Corrugation Farm Commercial Hopper Tanks (FCHT) 4-6 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 79
24"-48" Safety Cage Bell Sections
Attach the vertical supports to the hoop half assembly from the safety cage installation using 5/16" x 3/4"
bolts and nuts (with the heads on the inside of the cage). Assemble the special bell safety cage hoop
halves and attach to other end of vertical supports. The vertical supports will have to be bent at the flat
area to allow for the angle of the bell section. Attach the safety cage brackets to the ladder as shown in
the general detail information
on Page 12 . Once the safety cage brackets are installed, attach the bell
safety cage hoop half assembly to the safety cage brackets and tighten bolts.
NOTE: The safety cage bell section is to be used at the point of termination of the safety cage and should
be just above the concrete (generally 7' to 8').
Figure 7U 24" Bell
Figure 7V 48" Bell