Access door safety cage hoop assembly – Grain Systems Bin Accessories PNEG-1451 User Manual
Page 61
6. 2.66" Corrugated Commercial Hopper Tank 10-22 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks
61
Access Door Safety Cage Hoop Assembly
Before attaching any pieces to the ladder or platform, some pre-assembly is required. Attach the safety
cage brackets to the ladder section. (See general detail information
for proper installation
instructions.) Bolt the safety cage hoop adjuster plates onto the extension angle as shown in
For the middle hoop assembly, bolt the safety cage hoop adapters and safety cage hoop half together using
the proper holes, based upon the bin diameter.
Be sure to use the 5/16" x 3/4" bolt with the
head of the bolt to the inside of the safety cage. Bolt this assembly to the safety cage bracket and hoop
adjuster plate, tighten as you go. The bottom assembly requires two (2) hoop halves and will be positioned
just below the platform as shown in
. Use the safety cage hoop adjuster angle to secure the
two (2) hoop half assemblies to the vertical entrance angle on the platform assembly. To finish the
installation, secure the access door platform assembly to the base platform assembly using the safety cage
hoop adapters as shown in
.
for vertical support, safety cage and bell cage installation details to complete
the ladder assembly.
Figure 6AC
Extension angle (LS-6775)
(See general detail information
for proper installation.)
Base platform safety cage assembly shown for
reference only.
for installation details.
Left hand platform
assembly (
for assembly details.)