Access door safety cage hoop assembly – Grain Systems Bin Accessories PNEG-1451 User Manual
Page 34
5. 2.66" Corrugated Commercial Hopper Tank 4-9 Rings
34
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks
Access Door Safety Cage Hoop Assembly
Before attaching any pieces to the ladder or platform, some pre-assembly is required. Attach the safety
cage brackets to the ladder section.
Bolt the safety cage hoop adjuster plates
onto the extension angle as shown in
. For the middle hoop assembly, bolt the safety cage hoop
adapters and safety cage hoop half together using the proper holes, based upon the bin diameter.
Be sure to use the 5/16" x 3/4" bolt with the head of the bolt to the inside of the safety
cage. Bolt this assembly to the safety cage bracket and hoop adjuster plate, tighten as you go. The bottom
assembly requires two (2) hoop halves and will be positioned just below the platform as shown in
.
Use the safety cage hoop adjuster angle to secure the two (2) hoop half assemblies to the vertical entrance
angle on the platform assembly. To finish the installation, secure the access door platform assembly to the
existing safety cage assembly using the safety cage hoop adapters as shown in
.
for vertical supports, safety cage installation and bell safety cage installation
details to complete the ladder assembly.
Figure 5T
Left hand platform
assembly (
for assembly details.)
Extension angle (LS-6775) (See general detail
information
for proper installation.)
32" Safety cage assemblies shown
for reference only.
for
installation details.