Grain Systems Bin Accessories PNEG-1451 - Manual (Page 13)

4. General Detail Information
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 13
Ladder Section Assembly
Two (2) splice plates (LDR-4317) are required to attach each ladder section. The head of the bolt
should be to the inside of the ladder with the splice plate on the outside as shown in
Figure 4B .
Use 5/16" x 3/4" bolts for all connections.
NOTE: With most installations, the last ladder section installed to reach the ground, the base or the
intermediate platform should be cut to fit.
Figure 4B
Wind rings must be installed in relation to the ladder rungs as
shown here, to insure compliance with O.S.H.A. regulations.