Access door safety cage hoop assembly – Grain Systems Bin Accessories PNEG-1451 User Manual
Page 78
7. 4.00" Corrugation Farm Commercial Hopper Tanks (FCHT) 4-6 Rings
78
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks
Access Door Safety Cage Hoop Assembly
Before attaching any pieces to the ladder or platform, some pre-assembly is required. Attach the safety
cage brackets to the ladder section. (See general detail information
for proper installation
instructions.) Bolt the safety cage hoop adjuster plates onto the extension angle as shown in
For the middle hoop assembly, bolt the safety cage hoop adapters and safety cage hoop half together
using the proper holes, based upon the bin diameter.
Be sure to use the 5/16" x 3/4" bolt
with the head of the bolt to the inside of the safety cage. Bolt this assembly to the safety cage bracket
and hoop adjuster plate, tighten as you go. The bottom assembly requires two (2) hoop halves and will
be positioned just below the platform as shown in
. Use the safety cage hoop adjuster angle to
secure the two (2) hoop half assemblies to the vertical entrance angle on the platform assembly. To finish
the installation, secure the access door platform assembly to the existing safety cage assembly using the
safety cage hoop adapters as shown in
for vertical support, safety cage and bell cage installation details to complete
the ladder assembly.
Figure 7T
Safety cage assemblies shown for
reference only.
for
installation details.
67-1/2" Extension angle (LS-6775)
(See general detail information
for proper installation.)
Left hand platform
assembly (
for assembly details.)
Cage hoop bracket (See general
detail information
proper installation.)