Grain Systems Bin Accessories PNEG-1451 - Manual (Page 51)

6. 2.66" Corrugated Commercial Hopper Tank 10-22 Rings
PNEG-1451 Ladder, Safety Cage and Platform for Hopper Tanks 51
24"-48" Safety Cage Bell Sections
Attach the vertical supports to the hoop half assembly from the final safety cage installation using
5/16" x 3/4" bolts and nuts (with the heads on the inside of the cage). Assemble the special bell safety
cage hoop halves and attach to other end of vertical supports. The vertical support will have to be bent at
the flat area to allow for the angle of the bell section. Attach the safety cage brackets to the ladder as
shown in the general detail information
on Page 12 . Once the safety cage brackets are installed, attach
the bell safety cage hoop half assembly to the safety cage brackets and tighten bolts.
NOTE: The safety cage bell section is to be used at the point of termination of the safety cage and should
be just above the intermediate or base platform (generally 7' to 8').
Figure 6Q 24" Bell
Figure 6R 48" Bell