Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) PowerPack & Stinger w_EconoMind '06-07 For use with PowerPDA User Manual
Page 28
28
96813 v.9.0
6.
Remove the instrument panel
center bezel by unclipping the
retainer clips that secure the
instrument panel center bezel to the
instrument panel.
Note: The instrument panel center
bezel can be unclipped by prying with
your fingers on a corner. Avoid using
metal tools to pry off the instrument
panel center bezel or cosmetic
damage may occur.
7.
Remove the screws that secure
the instrument cluster bezel then
unclip the instrument center bezel by
prying off with your fingers.
8.
Remove the instrument cluster
bezel and set aside.
9.
Skip to Step 23 to continue.
Alternate Method- Drilling
Instrument Cluster Bezel using a
Right Angle Drill
10.
Remove the screws and unclip
the knee dash panel located under
the steering wheel and set aside.
11.
Remove the (3) screws at the
bottom of the instrument cluster
bezel.
12.
Gently pry on the upper left
corner of the instrument cluster
bezel and unclip the left corner only.
NOTE: Only the left corner of
the instrument cluster bezel will
be unclipped and lifted off the
instrument panel. The right side of
the instrument cluster bezel will
be attached with screws that are
not accessible for removal unless
additional steps are taken to remove
them.
13.
Obtain a piece of sheet metal or
similar material.
14.
Place the piece of sheet metal
behind the instrument cluster bezel
as shown in Figure 35.
Note: The piece of sheet metal is
intended to be used as a safety
barrier in the prevention of over
drilling.
15.
Skip to Step 23 to continue.
Installing the Power Level
Selector Switch in the accessory
cutout panel.
16.
Remove the screws and unclip
the knee dash panel located under
the steering wheel and set aside.
17.
Remove the accessory cutout by
pressing the retaining tabs located
on the backside of the part and set
aside.
18.
cut out the supplied template
(see Figure 37b) and align the
template onto the front of the
accessory cutout by centering it
to the part. Use masking tape to
securely hold down the template.
NOTE: Do not tape over the markings
on the template.
19.
Skip to Step 24 to continue.
Installing power level selector
switch in custom location.
CAuTIoN: Make sure that that
area of your choice can be
drilled without damaging any
components located behind the
surface. Remove panel as needed
to ensure no drilling interference.
20.
Locate an area of your choice
where you would like to install the
power level selector switch.
21.
cut out the supplied template
(see Figure 37b) and align the
template onto the front of the area of
your choice. Note: use the template
to align hole to be drilled. Use
masking tape to securely hold down
the template.
Figure 35
Figure 36 Power level selector switch, orientation of the tab on the washer