Rough Country 599S - Manual (Page 9)

44. Install the drive shaft spacer with supplied 10mm x 80mm hardware. See Photo 37. Tighten using a 8mm allen
wrench.
45. Using a 10mm wrench remove the brake line bracket from the driver and pass side frame. See Photo 38.
46. On the passenger side remove the brake line from the two factory clips. See Photo 39.
47. Install the new brake line bracket on the driver and passenger side with the stock hardware. See Photo 40.
48. Install the factory passenger side brake line in the new bracket using the supplied 5/16’ x 3/4” bolt, washer and nuts.
See Photo 41.
49. On the driver side, pull slightly on the brake line to allow the line to be installed on the new bracket. Secure the brake
line to the new bracket with the supplied 5/16” x 3/4” bolt, washers and nut.
50. Using a 13mm socket / wrench, tighten the supplied brake line hardware and 10mm for the stock hardware.
51. Install the supplied 3/8” studs in the strut spacers with a 9/16” wrench as shown in Photo 42.
PHOTO 37 PHOTO 38
INSTALL THE DRIVE SHAFT SPACER REMOVE THE BRAKE LINE BRACKET
PHOTO 39
PHOTO 40
PHOTO 41 PHOTO 42
REMOVE THE STEEL LINE FROM MOUNTS
INSTALL THE BRAKE LINE BRACKET
REINSTALL THE BRAKE LINE TO BRACKET INSTALL THE 3/8” STUDS IN SPACER