Rough Country 599S - Manual (Page 13)

8. To install the new e-brake bracket measure from the rear measure 1 5/8” and from the bottom measure up 1 3/8”
and mark hole to be drilled. See Photo 7 & 8.
9. Drill hole using a 11/32” drill bit. See Photo 9.
10. Install the new bracket as shown with the supplied 7/16” x 1” bolt, washers, nut in the factory hole and 5/16” x 3/4”
bolt, washer and nut in the drilled hole. See Photo 10. Tighten using a 19mm and 13mm socket / wrench.
11. Using a jack support the rear end and remove U-bolts using a 21mm socket. See Photo 11.
12. Install new block as shown in Photo 12 with the stock block on top of the new block. Raise the axle using the jack
until axle pins line up with hole and pin in block.
13. Install the axle u-bolts and tighten using a 22mm socket.
PHOTO 8 PHOTO 7
PHOTO 9 PHOTO 10
PHOTO 11
MEASURE 1 3/8” & MARK MEASURE 1 5/8” & MARK
DRILL USING 11/32” DRILL BIT INSTALL NEW BRACKET
REMOVE FACTORY U-BOLTS
PHOTO 12
INSTALL BLOCKS AND U-BOLTS