Rough Country RC617 - Manual (Page 8)

49. Install the six radiator drop bracket using stock bolts. Make sure you install into correct hole in drop bracket for 2 inch
body lift. The middle hole is for the 2” body lift. Make sure brackets are straight before tightening.
50. Install radiator onto brackets making sure A/C lines clear on the bottom of the radiator. Trim if necessary.
51. Using the supplied 1/4” nuts and tighten radiator to drop brackets using 11mm socket.
52. Install axle vent hose onto the top radiator stud.
53. Reinstall fan and radiator shroud with stock bolts using a
10 mm socket on shroud and 13mm for fan.
54. Reinstall coolant overflow bottle and hose.
55. Reinstall intake hose to air filter hosing and to throttle
body.
56. Reinstall clip on trans line to fan shroud.
57. Reinstall plastic jeep cover over sway-bar using stock
bolts.
58. Install airbag fuses back into fuse box and install glove
box.
59. Reconnect battery cables using 13mm wrench.
60. Recheck all fasteners, lines, wiring and hoses.
61. Make sure 4wd shifts smoothly. Adjust 4wd shifter under
vehicle using 13mm wrench. See Photo 39. Check steer-
ing make sure there is no binding.
PHOTO 37 PHOTO 38
PHOTO 39
INSTALL THE BRACKETS ON GRILL INSTALL THE RADIATOR ON BRACKETS
ADJUST THE 4WD SHIFTER
Continue to next pages for 97-02, 03-06 Manual Shifter extension installation and for 3” body lift shifter linkage
modification.