Rough Country 328S User Manual
Page 9
33. Install lower control arm using stock cam bolts.
See Photo 31.
34. Install skid plate using supplied 3/8
” X 1” bolts and 3/8” washers on the front cross-member. Use 14mm socket to
tighten.
See Photo 32.
35. Install the skid plate on the rear cross-member as shown in
Photo 33 with the supplied 3/8” x 1” bolts and washers.
36. Using 1 1/16 wrench and socket tighten cross member bolts.
See Photo 34.
37. Install axle shafts making sure the axle is fully engaged in the housing.
See Photo 35.
38. Install 3/8 studs into strut spacer using 14mm socket.
See Photo 36. It may be necessary to lightly tap studs in.
PHOTO 31
PHOTO 32
PHOTO 33
PHOTO 34
PHOTO 35
PHOTO 36
INSTALL THE CONTROL ARM
TIGHTEN SKID PLATE HARDWARE
INSTALL SKID PLATE
TIGHTEN HARDWARE
REINSTALL THE HALF SHAFTS
INSTALL THE STRUT STUDS
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)